Consumer
Products
Splitter

Splitter

4-Way, F-Type SWV3040W/27

Troubleshooting

Low picture quality using Philips HDMI cable

Implementing a passive signal 4-way splitter will technically attenuate the signal.

This might affect the picture quality negatively when:

  • The source (antenna) signal is too low
  • You are using long runs of coaxial cable

Solution:
Install an RF signal amplifier in front of the signal splitter, preferably close to the source.

This will ensure the fixed attenuation of the splitter (-7.4 dB) has no effect on the signal quality of the outputs.
Note: the attenuation does not depend on whether there is 1, 2, 3, or 4 outputs connected.

The information on this page applies to the following models: SWV3040W/27 , SWV3040W/17 .

Not what you are looking for?

Did we answer your question?

If not, contact us.